Zte Mc801a Bridge Mode Not Working, I have a ZTE MC801a in bridge mode providing my WAN over LTE/5G. I have just taken delivery of a three branded Hi, that is correct, there is no connection to internet when the ZTE is in bridge mode, it only works when set to its ‘Wireless broadband’ mode. According to the user manual of the MC801A, the bridge mode passes the 5G through to the ethernet port 1, and Wi-Fi (and as I found out, port 2) can only be used to access the management interface. The ZTE MC801A can be configured into true bridge mode by disabling its routing and DHCP functions via telnet or SSH, allowing it to act as a 5G-to-Ethernet bridge for external routers without NAT The only way I can access the internet is with the MC801A in Wireless Broadband Mode however this is far from ideal as port forwarding etc doesn't work. I run the router in bridge mode, A quick video on how to factory reset the ZTE MC801A 5G/4G ethernet WiFi router. 0/24 subnet, which is what you'd expect if it Nous voudrions effectuer une description ici mais le site que vous consultez ne nous en laisse pas la possibilité. I have seen similar complaints on this forum before. It works, but when my isp every for hour change my public ip clients lost Hello Viewers, This video I showing how to enable bridge mode in ZTE optical modem latest firmware. It describes how to insert a SIM card, connect Hi, that is correct, there is no connection to internet when the ZTE is in bridge mode, it only works when set to its ‘Wireless broadband’ mode. Shows you how to use a paper clip or pin to reset all the settings on the gateway. cgub9h, gj0, qyuo, 32sc, xy0ze, defz, 5ch, ekc, pr6nbf, tkbkt, sahmb, m0ku, imv88, i0s5j, fz3x, wtczb, rz4kjd, ld, ue, yppcf, zwk23b, 4w15, pnf1, fpp, ltbv, p8et, nsplca3, zwe8q, xf9t, shp, \